RTI TheaterTouch T2 Instructions d'exploitation télécharger pdf (Page 14)

Introduction

GETTING STARTED

Start by inserting the battery connector into the mating plug on

the T2-C. Make sure the connector is oriented properly before

attempting to insert it. Next, turn the unit on by sliding the power

switch into the “ON” position (toward the battery).

After power is applied, the T2-C will take approximately ten

seconds to load the operating system, the application software,

and the user program. This long delay only occurs from a power-

down state. During normal use the T2-C turns-on instantly from

its sleep mode.

The T2-C is turned-on by touching any area of the display or any

keypad button. If the tilt sensor is enabled, picking up the unit

will also turn it on.

Power

Switch

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

Pas de commentaire

RTI TheaterTouch T2 Instructions d'exploitation Page 14